Every Bluebot device goes through a two-stage quality process before it reaches you. This ensures accuracy, reliability, and consistent performance right out of the box.
Factory Calibration & Quality Checks
Before leaving the factory, each Bluebot is:
Factory calibrated to ensure accurate flow measurement
Verified for proper sensor performance and functionality
Checked to confirm core systems are operating within expected parameters
This step establishes a reliable baseline so the device is ready for installation and setup when it arrives.
Warehouse Quality Control
After factory calibration, Bluebot devices are sent to our Monterey, California warehouse, where they undergo additional quality checks before shipping to customers.
In our Monterey lab, each device is:
Inspected for physical condition and build quality
Verified to power on and enter setup mode correctly
Checked to ensure communication and core functionality are working as expected
Installed using the same app our customers use
Installed on a pipe, and had flow rate checked
Reviewed for accuracy and overall readiness for customer use
Only devices that pass these checks are approved for shipment.
Our commitment to quality
This process—factory calibration followed by warehouse quality control—helps ensure that every Bluebot arrives ready to perform reliably in your installation.
If anything doesn’t behave as expected after installation, our support team is always here to help troubleshoot, adjust, or replace the device if needed.